Command Start CS-580i FM Guía de instalación descargar pdf (Pagina 10)

P. 10 Installation Guide

The System must exit Valet Mode before a Transmitter Programming procedure can be

carried out:

Getting out of Valet Mode

1. Turn the Ignition Key to the IGNITION ON (RUN) position.

2. Within 3 seconds, press and release the Valet Button (the L.E.D. will go out)

(See section Valet Operation, in the User Guide, for more details on the use of Valet

Mode.)

As the System exits Valet Mode, you will have 30 seconds to carry out the Transmitter

Programming procedure before the Alarm rearms.

The Transmitter Programming Procedure

1. Flash the Hood Pin switch (see Table 1)

– The Parking Lights will stay ON for up to 20 seconds.

– Before the lights go out, turn the Ignition Key to the IGNITION ON (RUN) position.

– Immediately turn the Ignition Key back to the OFF position.

Press and hold the LOCK button and keep it down until the Parking Lights flash

5 times quickly and the siren will chirp twice.

– The System has stored the code of the Transmitter into memory.

2. To exit: close the Hood.

Table 2: Programming a Transmitter

To program a Transmitter on the second vehicle for Multi-car Operation, you must press

the TRUNK and LOCK buttons simultaneously (instead of LOCK or UNLOCK) in transmitter

programming procedure.

Entering Programming Options Mode

The System is equipped with three custom programming Modes that allow the installer to

custom-fit the system outputs according to installation requirements. The Programming

Options are designed to facilitate interfacing with all vehicle types. (See section Table of

Programming Options later in this Guide.)

1. Flash the Hood Pin switch (see Table 1)

– The Parking Lights will stay ON for up to 20 seconds.

– Before the lights go out:

2. Press and hold the Brake Pedal,

– And press one of the following buttons on the Transmitter:

• LOCK..................to access Mode 1;

• UNLOCK..............to access Mode 2;

• TRUNK................to access Mode 3.

The Parking Lights will flash and the Siren will chirp once, twice or three times to

confirm entry into a Mode.

3. Release the Brake Pedal.

Table 3: Accessing modes

Note

The Unit will stay in the selected programming Mode until the Hood Pin-switch or the

Brake Pedal is pressed again. Therefore take your time to make the proper

selection. Pressing the Brake Pedal will take you back to the Programming Centre,

where you can select a different Mode.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Comentarios a estos manuales

Sin comentarios

Command Start CS-580i FM Guía de instalación Pagina 10

Comentarios a estos manuales