Command Start CS-580i FM Guía de instalación Pagina 21

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 22
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 20
Installation Guide P. 21
Diagnostics – Parking Light Flash Table
Flashes Description
1
Doors locked, Alarm and Starter Kill armed.
End of Run Time.
TRUNK button pressed
Start signal received by the System.
Cold Weather Mode cancelled.
Cannot start after maximum number of attempts is reached.
2
Doors unlocked, Alarm and Starter Kill disarmed.
Run Time cancelled.
Exit Remote Valet.
Remote start attempt cancelled by remote.
3
Entering Cold Weather Mode.
Entering Remote Valet.
4
+12 V where detected on the brake line and cranking was cancelled.
Entering Tach-programming Mode
5
New Transmitter programmed.
Tach programmed.
6
A remote start was attempted while a Tach or a vacuum signal was detected
before cranking.
8
Unit reset: occurs when the Unit is reset to the factory defaults.
10
The Hood Switch line went to ground during cranking or Run Time.
1 – pause – 2
There was an attempt to start the vehicle while the System was in Valet
Mode.
2 – pause – 2
There was an attempt to start the vehicle while the System was in Home
Valet Mode.
ON solid
Cold Weather Mode: the Brake Pedal is being held down.
ON 2 sec.
The Hood is up and the Hood Switch line went to ground. This is step one of
the Programming Centre procedure.
ON 3 sec.
First press of the
START/STOP button under Safe Start.
ON 4 sec.
Locking or unlocking a Door (with Door pulses configured to 4 sec.)
ON 25 sec.
The Hood Pin-switch has been pressed twice: the Unit went into step 1 of the
Programming Centre procedure, and no Transmitter activity was detected for
20 seconds.
Or the Unit went into step 1 of the Transmitter Programming procedure and
no activity was detected for a few seconds. The Unit has exited the
Transmitter Programming procedure.
Irregular
If the unit gives irregular signals (1 to 10 flashes followed by a pause,
followed by further flashes), the system is playing back Start Failure Codes.
This occurs when the Hood Pin-switch is pressed three times.
Constant
flashes
up to 30 sec.
In Horn Mode: Alarm condition generated by an intrusion, by Panic Mode or
when the System is powered up.
Constant
flashes
up to 60 sec.
In Siren Mode: Alarm condition generated by an intrusion, by Panic Mode or
when the System is powered up.
Vista de pagina 20
1 2 ... 16 17 18 19 20 21 22

Comentarios a estos manuales

Sin comentarios