Command Start CS-580i FM Manual de usuario descargar pdf (Pagina 25)

Manual PC6D CANopen Page

Part B

5 COMMANDS

These pages describe the ASCII commands as they must be used e.g. by the DOP software.

At each command the equivalent CAN index and sub-index are given for reference.

For better clarity, all commands are divided into groups as described on the following pages.

PART B...............................................................................................................................25

5 COMMANDS................................................................................................................25

5.1 SYSTEM DIAGNOSIS COMMANDS – ID, IV, IS ..........................................................26

5.2 CALIBRATION COMMANDS – CE, CM, DS, DP, CZ, CG, ZT, FD, CS......................27

5.3 MOTION DETECTION COMMANDS – NR, NT.............................................................30

5.4 FILTER SETTING COMMANDS – FM, FL, UR ............................................................31

5.5 SET ZERO/TARE AND RESET ZERO/TARE COMMANDS – SZ, RZ, ST, RT.................33

5.6 OUTPUT COMMANDS – GG, GN, GT, GS ...............................................................35

5.7 SETPOINT COMMANDS - SN, HN, AN.......................................................................36

5.8 COMMUNICATION SETUP COMMANDS – AD, BR, TERMINAL RESISTOR.....................38

5.9 TRIGGER COMMANDS – SD, MT, GA, TE, TR, TL ..................................................39

5.10 TRIGGER SPECIAL COMMANDS– RW, TT, TS, DT, TW, TI, HT...............................42

5.11 SAVE CALIBRATION, SETUP & SETPOINT PARAMETERS COMMANDS – CS, WP, SS...45

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 44 45

Sin comentarios

Command Start CS-580i FM Manual de usuario Pagina 25