Command Start CS-580i FM Manual de usuario descargar pdf (Pagina 40)

Page Manual PC6D CANopen

TL Trigger Level [ 2500sub01 ]

Set the trigger level for rising edge start of measurement. Permitted values are in the

range 0…262143.

Master (PC / PLC) sends Device responds Result

TL T+99999

Request: TL=99999

TL_1000 OK

Setting: TL=1000

With regard to the trigger commands SD and MT, a check weighing will automatically start

when the weight overshoots by e.g. 1.000d (increments), e.g. 100,0 g.

Factory default: 199999

TE Trigger Edge [ 2500sub02 ]

Issuing the TE command selects rising or falling edge trigger. Parameter = 0 select falling

edge and parameter = 1 select rising edge.

Master (PC / PLC) sends Device responds Result

TE E:001

Request: TE=1

TE_0 OK

Setting: TE=0

Factory default: 0 [falling edge]

Note: This command cannot be used together with the TL command.

TR Trigger RPDO2 [ 00 80 ]

[This command will start the measuring cycle in the same way as the hardware trigger

input.]

Master (PC / PLC) sends Device responds Result

TR OK

Trigger started

Note: This function can be used as a soft trigger in a check weigher application (firmware

102.183).

[ Special returned values are:

- 99999 = trigged measurement in progress

- 88888 = Re-Trigger in progress

- 99996 = Tried to change Tare or Zero before end of measurement ]

[ The Trigger function can also be stopped by sending 01 instead of 80 with RPDO2 [00 01]. ]

Factory default: 199999

1 2 ... 35 36 37 38 39 40 41 42 43 44 45

Sin comentarios

Command Start CS-580i FM Manual de usuario Pagina 40